Concrete Contractor in Marysville, WA - Driveways and Patios That Drain Right
Arlington Concrete is a concrete contractor based in Arlington, and we pour driveways, patios, walkways, garage floors, steps and footings in Marysville, with the ground prepared and the water's path worked out before any concrete arrives.
Concrete work for Marysville homes and lots
Marysville is one of the cities around our base in Arlington where we pour and repair concrete, for homeowners and for small business owners who need a pad, a lot or a foundation done properly. The work runs from a cracked driveway or a sunk walk to a new patio, garage floor, steps or footings.
I spent years with a big commercial concrete outfit, where a job got planned long before the first truck showed up, and I started this business in 2023 to bring that planning to homes and smaller properties. So the first visit is mostly questions, about what's under the old slab, where the water goes and how you use the space.
What we check before the pour
Before I price a job, I look at the subgrade, the dirt and gravel the slab sits on, at where water runs across the lot and at how the old concrete failed, if there's any. Those answers decide how deep we dig, what base we pack and which way the new slab falls, so it doesn't repeat the old one's problems.
- A base that settles. Where a base was only raked level instead of dug out and packed, the slab settles with the dirt underneath and cracks or tips.
- Water toward the house. If nobody checked where the water runs, a slab can fall toward the house or hold puddles, so we set the grade to carry it away.
- Cracks nobody chose. Control joints are the cuts that give a slab a straight place to crack, and when they're cut late or skipped, it cracks wherever it wants.
Concrete jobs we do for Marysville homeowners
Where a driveway or walk has sunk at one corner, cracked across the middle or started holding water by the garage, I want to know whether it's the base, the water or both before we pour again. Drainage gets a close look in Marysville, since the county's hazard overview names flooding among the natural hazards of greatest concern in the area, and a new slab has to send water somewhere sensible.
Other jobs start from scratch, like a concrete patio off the back door or a wider walk to the street. If the budget's tight, I'd cut the fancy finish before the base, because nobody sees the base on day one but it decides whether the patio stays flat.
How we cover Marysville
We work Marysville from our base in Arlington, the same way we cover Lake Stevens and Everett. Call or send the form and I'll come out to measure. Price moves with size, tear-out and base work, and the schedule turns on the permit check and a dry day to pour.
Tell us about your concrete job
Send the rough size, what's there now and a few photos, or tell us on the phone. We reply within one business day and set a time for me to come out.
(360) 474-2804- Free on-site estimate
- Written scope, in and out
- No pressure to book
Marysville concrete questions
Do I need a permit for a concrete driveway in Marysville?
We check that with the city before we schedule anything, since Marysville's Community Development department takes all permit applications through its online permit portal, grading and clearing permits included. Then we tell you plainly what we'll file and what, if anything, falls to you.
Does a concrete contractor need a license in Washington state?
Yes, Washington requires every construction contractor to register with the state labor department and be bonded and insured. The bond is $30,000 for a general contractor or $15,000 for a specialty one, and on a home job of $1,000 or more the contractor owes you a disclosure notice. We're fully licensed and insured.
How much does a new concrete driveway cost in Marysville?
The price comes down to the size, the thickness, how much old concrete has to come out, how much base work the ground needs and the finish you pick. I come out, measure and send a written estimate that spells out what's in it and what isn't, so you can compare it line by line.
Will a new concrete slab crack like my old one did?
Concrete can still crack, but a slab on a dug-out, packed base with control joints cut on time usually cracks along those lines instead of across the middle. We also try not to pour in midday heat, which can leave a weak, dusty top, and we add rebar, steel inside the slab that holds it together, where the job calls for it.
How long until I can drive on a new concrete driveway?
You can walk on it well before you can drive on it, because concrete keeps gaining strength while it cures, the waiting period after the pour. I'll tell you the wait for your slab when we set the date, so you can plan where the car goes in the meantime.